Furnace Installation in Sammamish, WA

Replacing a furnace in a Sammamish home is a chance to cut gas bills by 15–20% and lock in reliable heat for the next two decades. HotWire designs each install around your Plateau home’s actual heat load, ductwork condition, and future plans.

Furnace Installation Questions from Sammamish Homeowners

  • Is a 96% AFUE furnace really worth the upgrade from my 80%? — Over a typical Sammamish winter, the fuel savings from a 96% unit vs an 80% is 15–20% on the gas heat portion of your bill. For most Plateau homes that’s $250–$450 per year, which adds up over 20 years.
  • Two-stage or variable speed — is the extra cost worth it? — For homes with existing comfort complaints (cold rooms, temperature swings, dust) yes. Variable-speed blowers and modulating gas valves smooth out the operation and reduce hot-cold cycling. For homes with a well-balanced duct system and few complaints, single-stage 96% AFUE is a fine choice.
  • Do I need a new thermostat with the new furnace? — For two-stage or modulating equipment, yes — a communicating thermostat unlocks full capability. Most Sammamish homeowners already have Ecobee or Nest smart thermostats and we integrate with those where possible.
  • My gas meter is small — enough capacity for a new furnace? — Older Sammamish homes sometimes have 250 CFH gas meters that need upgrading if you’re adding a tankless water heater and high-input furnace together. We coordinate with PSE for meter upgrades when required — usually free through PSE.
  • Will the new furnace fit in my existing closet? — Modern 96% furnaces are physically smaller than 80% units they replace, so closet fit is almost never an issue. Venting changes from B-vent metal to PVC, which we route through the wall or attic per code.
  • Can I keep my existing ductwork? — Usually yes, with a static pressure check and sealing of major leaks. If your ductwork is undersized (common in 1990s Pine Lake homes) we discuss modifications or return-air upgrades before install.
Single-stage 96% AFUE furnace installed: $6,200–$7,800. Two-stage 96% AFUE: $7,500–$9,800. Variable-speed modulating: $9,500–$12,500. Prices include equipment, install labor, permits, disposal, and startup. Rebates from PSE and federal 25C tax credit typically return $400–$800 net.
Single-day install for most Sammamish furnace replacements — crew arrives 8 AM, system runs by mid-afternoon. Complex changes (venting reroute, new gas line, panel work, ductwork mods) can extend into a second day. We give you a specific timeline at quote and stick to it.
Ten-year parts warranty from every major manufacturer (Trane, Lennox, Carrier, Bryant, Rheem) on registered systems. HotWire's one-year labor warranty is included; extended labor warranty up to 10 years available at install for around 5–8% of system cost. Registration is done for you as part of our closeout.
Yes — mechanical permit for furnace replacement, potentially a gas piping permit if we're modifying supply lines. We pull both as part of the job and coordinate the final inspection. You don't visit any city offices.

Furnace Installation Options for Sammamish

High-efficiency 96%+ AFUE gas condensing furnaces are our most-installed unit across Sammamish — Trane XC95m, Lennox SLP99V, Carrier Infinity 59MN7, Bryant Evolution 987M. These modulate gas input in fine increments, run variable-speed ECM blowers, and vent through 2-inch or 3-inch PVC. Two-stage 96% units (Trane XR97, Lennox EL296V, Carrier Performance 59TP6) offer significant comfort improvement over single-stage at a moderate price bump. For value builds and rental properties, single-stage 96% units from Rheem, Ruud, Goodman, Amana, and Payne provide efficient heat at lower upfront cost. Larger custom Sammamish homes may need 100k+ BTU inputs or dual furnaces for zoned systems — we design those and handle the gas piping upgrades that go with them.

Every Sammamish furnace install starts with a home walk-through by our designer — not a phone quote. We check gas meter capacity, existing electrical, current ductwork condition and sizing, venting path options, and current comfort complaints. Manual J heat loss calculation determines the correct BTU input for your home; oversized furnaces are a bigger problem than undersized in Sammamish’s mild climate. You get a written proposal covering equipment, install labor, permits, warranty, and rebate credits.

Install day: crew arrives at 8 AM, existing furnace disconnected and removed, new unit set and connected to gas, electrical, condensate, and venting, ductwork transitioned and sealed, startup and commissioning with combustion analyzer and static pressure gauge, walkthrough with homeowner. Most Sammamish furnace installs finish by 2–4 PM the same day. Two-story homes with attic ductwork may extend into a second day if we’re re-routing venting.

Financing runs 0% for 12–18 months through our partners. City of Sammamish permits are pulled and inspections coordinated. PSE rebate paperwork and federal tax credit documentation are prepared and submitted for you at closeout.

Testimonials
HotWire HVAC Refrigeration & Appliance Repair place picture
5.0
Based on 52 reviews
powered by Google
Midori Tanouye profile picture
Midori Tanouye
4 months ago
Olek fixed my dryer, quickly and at a very reasonable cost. Same day appointment, very easy. :) Thanks!
Alex Diaz profile picture
Alex Diaz
4 months ago
Olek, did an great on fixing my dryer. Came in did diagnosis and was fully done in a matter of hours. Thank you for hour service!
Peter profile picture
Peter
6 months ago
Our refrigerator stopped properly cooling. While it wasn't completely out. it just wasn't cool enough to keep things fresh. Called Hotwire on Friday. Technician came out Saturday morning. Vlad is a young fellow but very knowledgeable. He quickly diagnosed the problem which was a frozen stuck fan. After removing the freezer tray, he pulled out his magic steamer gadget and defrosted the coils. He did a thorough job cleaning up and putting everything together. Happy to have things running again ahead of Superbowl Sunday.
Eli Pinkerton profile picture
Eli Pinkerton
6 months ago
The team here was great. I had an issue with a dishwasher, they were quick to diagnose it and informed us of reasonable alternatives. We chose to repair it, they ordered the part and installed it. Throughout, they were communicative, helpful, and nice. The price was reasonable as well. I'd go back to them for any appliance issues in the future!
Dan Burbank profile picture
Dan Burbank
6 months ago
Great experience. Vlad was on time and very professional. FIXED the issue and was a fair price
Thank you.
Cameron S profile picture
Cameron S
7 months ago
My LG fridge/freezer stopped cooling. I called Rain City around 8pm, and they were able to get a technician out before Noon the next day. After inspecting the problem the tech informed me that the compressor went out, which is a somewhat common problem on LGs. He'd be able to fix it right away if I wanted. Given the labor needed to replace the compressor, I decided to just replace the refrigerator instead.
I was pleased how he explained the issue and presented me with various options. I'd definitely recommend.
Ruben Contreras profile picture
Ruben Contreras
9 months ago
Vlad was wonderful. He brought our microwave back to life. Saved us a costly replacement. He was professional and clean. Service was the day after our call. Price was as expected. I would highly recommend their service.

Neighborhoods and Areas We Serve in Sammamish, WA

We provide HVAC and appliance repair throughout Sammamish, including:

Nearest HotWire location serving Sammamish — Woodinville, WA