Heating Installation in Redmond WA

A heating install is a fifteen-to-twenty-year decision, so we treat the consultation with the same weight. Our estimator walks the house, runs a load calculation based on square footage and insulation, checks ductwork condition, and lays out real numbers for each option — furnace, heat pump, ductless — with rebate-adjusted totals so you can compare apples to apples.

Once you choose, our licensed crew pulls the Redmond city permit, coordinates the electrical and gas work, installs the equipment, and schedules the required inspection. We’re careful with the details that get skipped by lower-bid installers — proper refrigerant charge on heat pumps, correct static pressure on furnace airflow, condensate drainage that won’t back up in year three.

If your project qualifies for Energy Smart Eastside or PSE rebates, we prepare the paperwork on your behalf and submit it as part of the job. The workmanship warranty on our installation labor stacks with the manufacturer’s equipment warranty, so you’re covered on both sides for years.

For Redmond installs converting from gas to a heat pump, we also handle the decommissioning side properly: capping the gas line to code, coordinating with PSE for meter changes if needed, and disposing of the old equipment. These transition details are where cheaper installers cut corners, and they’re the ones that cause problems years later when you sell the home or need a permit for something else.

For Redmond conversions specifically, the Energy Smart Eastside program has changed the economics of heating equipment decisions in ways many homeowners haven’t fully internalized. What used to be a straightforward furnace replacement is now a genuine choice between staying on gas, converting to a heat pump, or in some cases combining a high-efficiency furnace with a heat pump as a dual-fuel system. We walk through all three options rather than defaulting to any single answer.